You should pin it to a wall in easy view.

Pipe mismatch mistakes are very common in projects, often because the project manager (or procurement manager in larger projects) did not match the designed pipe ends to the supplied equipment.

If you don’t already have a clear copy of the pipe specifications, most good drafting departments will have one or a source to get one from.

Related Posts

1. Check Standards for Pipes
2. Training and Self Improvement Library
3. Risk Analysis

Remember that imported equipment might come with different flange drilling than what your pipe flanges have.

There are a number of different flange and pipe standards, make sure you allow for this in the designs. Most standards (such as ANSI, BS, AS, PN etc) are not interchangeable.

The details you give your design team need to match the right standard. You could be ordering a pump with a AS2129 Table D flange, but your designers might assume the project is using a British standard, or ISO standard because other equipment is listed as matching those specs.

It is easy to overlook this. In fact if you aren’t careful you will only realise when your installation team calls to tell you that the pumps and pipes don’t match. Then you waste time and money working out a solution.

While on this topic, make sure you understand the differences between the standards dimensions and also the faces of the flanges they describe (e.g. flat faces, raised face, etc).

Most suppliers of pipes will have a page showing sizes, flanges, drilling, and comparisons in their catalogue.

Early planning and checking can save a lot of time later in the project.

Related Posts

1. Pipe Sizes
2. Errors and Omissions
3. Clear Specifications